Silicon Carbide in Qatar

Silicon Carbide grit, SiC, is a quick, extremely hard abrasive. It is normally dark in shading. It is more diligently than aluminum oxide grit and is near the hardness of precious stone on the Mohs scale. These qualities make it a very forceful media. It is regularly utilized in impacting applications where the workpiece would be brazed subsequent to impact. The use of Silicon Carbide grit abrasive paper is the best and helpful system for pulverizing metallic metallographic models. Albeit various attributes of silicon carbide grit are speedily available, simply the silicon carbide grit powder gives the most consistent results and most important crushing rates. Silicon carbide powders are taken care of at higher temperatures than lower-quality silicon carbide powders.

Silicon Carbide Grit Manufacturer

The silicon carbide grit manufacturer procures a more complete reaction between the silica and carbon portions. The ensuing pearl structure is a hexagonal-rhombohedral diamond structure with a hardness of about 2500 HV. This pearl structure makes the silicon carbide grit manufacturer an ideal abrasive for cutting and pulverizing considering its high hardness and sharp edges. Silicon carbide grit is moreover somewhat delicate and thusly slices adequately to convey sharp new edges (self-sharpening). The resulting Silicon Carbide grit abrasive is a fabulous abrasive for extending cutting rates while restricting surface and subsurface mischief. For metallographic arranging, Silicon Carbide manufacturer abrasives are applied or covered onto abrasive beating papers. To fabricate the strength similarly as to improve the ability to wipe out used papers, a thin mylar film backing is clung to the Silicon Carbide grit paper. Silicon Carbide grit abrasive paper is available taking everything together with normal grit sizes going from 60 grit to 1200 grit.

Different Silicon Carbide Grit Sizes

Silicon carbide shows up in two diverse glasslike structures: hexagonal α-silicon carbide is the primary item, while cubic β-silicon carbide is shaped at lower temperatures. Silicon carbide grit (SiC) is made in an opposition curve heater charged with a combination of around 60% silica sand and 40 percent finely ground petrol coke. A limited quantity of sawdust is included along with the blend to build its porosity so the carbon monoxide gas framed during the cycle can escape uninhibitedly. Normal salt is included along with the blend to advance the carbon-silicon response and to eliminate contaminations in the sand and coke. During the warming time frame, the heater center reaches roughly 2200°C (4000°F), so, all things considered, a huge segment of the heap takes shape. Toward the finish of the run, the heater contains a center of freely weave silicon carbide precious stones encompassed by unreacted or incompletely responded crude materials. The silicon carbide precious stones are taken out to start preparing into abrasive grains.

Silicon Carbide Properties

• Low density.
• High strength.
• Low thermal expansion.
• High thermal conductivity.
• High hardness.
• High elastic modulus.
• Excellent thermal shock resistance.
• Superior chemical inertness.

Silicon Carbide Grit Supplier in India

We are the best silicon carbide grit Supplier in India. We offer an abrasive shot, Steel Shot, SS Shot, Steel Grit, Garnet sand, Quartz shot, Aluminum oxide, glass beads blasting for stainless steel, etc, and a qualitative range of industrial steel abrasive products.

To enable us to quote for your requirement, kindly give us the following info –

1.      Particle size required (You may choose from above or give your own range).

2.      Packing required.

3.      Quantity required with the delivery schedule.

4.      Destination port.

5.      Payment terms.

6.      Discharge rate at the destination, if in break-bulk.

7.      Any other point which may impact the quote.

We can also offer ungraded material for shipments in bulk in any quantities as desired by our buyers on FOB or CNF FO basis terms.