Chilled Iron Grit Manufacturer in Delhi

Chilled Iron Grit Manufacturer

When a localized area of gray iron is cooled very rapidly from the melt,  iron is made at the place that has been cooled. This sort of white iron is named chilled iron grit supplier. A relaxing iron casting is often produced by adjusting the carbon composition of the white iron in order that the traditional cooling rate at the surface is simply enough fast to supply white iron while the slower cooling rate below the surface will produce gray iron. The depth of chill decreases and therefore the hardness of the chilled iron grit supplier zone increases with increasing carbon content. Chilled iron grit supplier isn't burn-sensitive and features a high specific grinding energy due to its high carbide content. Its hardness is approximately 50 HRc and therefore the maximum surface roughness achieved on the machine is 0.5 μm, therefore a typical structure bonding system is employed that's usually between 23 and 27% volume of the wheel. The grain content is typically 50 vol.%, and wheel speeds are usually up to 120 m/s. To summarize, a cleaning station contains a rough screen to get rid of the trash, a storage sand blasting machine, a metering device to supply a controlled flow of abrasive, and an air-wash classifier that removes dust and fines.

Size Available

Physical Properties

• Hardness of new grain- ± 640 HV (56 HRC)
• Grain shape- Angular
• Density- Approx. 7,8 g/m³
• Bulk density (Dependent upon granular size)- Approx. 3,0 - 4,6 g/m³
• Microstructure- Martensitic

Chemical Properties

• C-2,80 - 3,20%
• Si- 1,00 - 1,50%
• Mn- 0,35 - 0,90%
• P- 0,10 - 0,20%
• S- 0,07 - 0,12%
• Fe- Remainder

Packaging

• 25 kg paper or plastic bags on pallet up to 1 ton.
• 1 ton loose in a bulk bag.
• Another packaging on request.

Chilled Iron Grit Supplier in India

We are the leading chilled iron grit supplier in India. We are also the supplier and exporter of abrasives such as glass beads, cut wire shot, copper slag, steel shot, aluminum oxide, and garnet sand. Our large range of products and are checked on various parameters, such as density, physical and chemical properties, microstructure, hardness, durability. We are focused on our quality products and customer satisfaction.

To enable us to quote for your requirement, kindly give us the following info –

1.      Particle size required (You may choose from above or give your own range).

2.      Packing required.

3.      Quantity required with a delivery schedule.

4.      Destination port.

5.      Payment terms.

6.      Discharge rate at the destination, if in break-bulk.

7.      Any other point which may impact the quote.